Rear Floor Covering

Rear Floor Covering

Removing

- Remove front seats. Refer to => [ Standard Seat ] Standard Seat.

- Vehicles with a comfort reclining seat: remove the support channels. Refer to => [ Support Channels ] Support Channels.

- Remove rear seat bench. Refer to => [ Rear Bench Seat ] Rear Bench Seat.

- Vehicles with individual power rear seat: Remove rear seat pan. Refer to and remove center seat cushion. Refer to => [ Center Seat Cushion ] Center Seat Cushion.

- Remove the front center console side trim panel.

- Vehicle with rear center console: unclip the side trip panel for the rear center console from the frame located at the front of the console

- Remove the rear sill panel trim. Refer to => [ Rear Sill Panel Trim ] Rear Sill Panel Trim.

- Remove the B-pillar lower trim. Refer to => [ Lower B-Pillar Trim ] Lower B-Pillar Trim.

- Remove rear footwell vent. Refer to => [ Rear Footwell Vent ] Rear Footwell Vent.

- Remove spreader clips - arrows - by carefully pressing in the clamping pin approximately 5 mm until it audibly engages in the spreader clip.






- Lift front floor covering - 1 - and pull it up.

• Make sure the floor covering does not tear at the openings.

- Fold the floor covering and remove it through a door.

Installing

- Fold floor covering and lay it in the vehicle.

- Align floor covering so that the openings align.

Installation is performed in reverse order of removal, noting the following:

Installation note: For example tightening specifications, replace components => [ Foot Rest and Floor Covering Assembly Overview ] Foot Rest and Floor Covering Assembly Overview.