Camshaft Position Sensor (G300)/(G301), Exhaust Side

Camshaft Position Sensor (G300)/(G301), Exhaust Side

Removing

Cylinder Bank 1 (right):

- Remove the air filter housing upper section. Refer to => [ Air Filter ] Air Filter.

Cylinder Bank 2 (left):

- Remove bolt - arrow -.






- Disconnect the electrical connector to the engine coolant level warning switch (F66) on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses - 1 - and - 2 - attached.

- Disconnect the connector - 1 -.

Continued for Both Sides:






- Remove the bolt - arrow - and the camshaft position sensor.

• The illustration shows the camshaft position sensor 4 (G301) (left).

Installing

• Tightening specifications, refer to => [ Ignition Overview ] Ignition Overview.

Installation is performed in reverse order of removal, noting the following:

• Replace O-rings.

- Install the air filter housing upper section. Refer to => [ Air Filter ] Air Filter.