Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Chain 1






Camshaft Timing Chains

Removing

The transmission is removed.

- Remove timing chain lower cover. Refer to => [ Lower Timing Chain Cover ] Lower Timing Chain Cover.

- Remove the camshaft timing chains from the camshafts. Refer to => [ Camshaft Timing Chains ] Chain 2.







If the running direction is reversed on a used camshaft timing chain, it could be destroyed.

Paint arrows to mark the timing chain running direction so it can be installed again.

- Remove bolts - 1 and 2 - and remove the left chain tension and left camshaft timing chain.

- Remove bolts - 1 and 2 - and remove the right chain tension and right camshaft timing chain.






Installing

Tightening specification, refer to => [ Camshaft Timing Chains Overview ] Camshaft Timing Chains Overview.

If the tensioning element was removed from the chain tensioner, then the installation position must be noted: Hole in housing floor faces toward chain tensioner, piston faces toward tensioning rail.

Replace bolts that are tightened to the specification.

Replace the seals


Risk of damaging valves and piston crowns.

If the camshafts are rotated, crankshaft may not rest with any piston at "TDC".

- Press the guide rails for the left or right camshaft timing chain tensioner in - arrow - as far as the stop and secure the chain tensioner with a (T40071).






- Clean the oil strainer - 2 - in both chain tensioners if necessary.






- Position a new seal - 3 - on the rear of the chain tensioner - 1 -.

- Insert the chain tensioner on the left cylinder head and position the camshaft timing chain according to the markings made during removal, as shown in the illustration.






- Fasten bolts - 1 and 2 -.

- Insert the chain tensioner on the right cylinder head and position the camshaft timing chain according to the markings made during removal, as shown in the illustration.






- Fasten bolts - 1 and 2 -.

Install in reverse order of removal paying attention to the following:

- Position the camshaft timing chain on the camshafts => [ Installing ] Camshaft Timing Chains.

- Install timing chain lower cover. Refer to => [ Lower Timing Chain Cover ] Lower Timing Chain Cover.