Intake Manifold, Lower Section, With Fuel Rail Assembly Overview

Intake Manifold, Lower Section, with Fuel Rail Assembly Overview






1 Bracket

• For the flange and fuel rail

2 Gasket

• Replace

3 Sleeve

4 Intake manifold lower section

• The intake manifold flaps must be all the way open in the intake manifold channel when the intake manifold lower section is being installed

• Removing and installing, refer to => [ Intake Manifold, Lower Section, with Fuel Rail ] Intake Manifold, Lower Section, With Fuel Rail

• 10 Nm

5 Support ring

• Replace if damaged

• Make sure it fits correctly when installed

6 O-ring

• Replace

• Coat with clean engine oil

7 Spacer ring

• Replace if damaged

8 Fuel injector

• Removing and installing, refer to => [ Fuel Injectors ] Fuel Injectors

9 Combustion chamber seal

• Do not grease ring or treat with any other lubricant

• Replace

10 Actuator lever

• For the vacuum actuator

11 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

12 Vacuum hose

• From the Intake Manifold Runner Control (IMRC) Valve (N316)

13 Intake manifold runner control vacuum actuator

14 Intake Manifold Runner Position Sensor 2 (G512)

15 Bolts

• 2.5 Nm

16 Threaded support

• 40 Nm

17 Cover

• For the spray nozzle valve and the oil check valve

18 To vacuum reservoir

19 High pressure fuel line

20 Bolts

• 9 Nm

21 Fuel rail

• Removing and installing, refer to => [ Intake Manifold, Lower Section, with Fuel Rail ] Intake Manifold, Lower Section, With Fuel Rail

22 Bolts

• 9 Nm

23 Bolts

• 9 Nm

24 Bolts

• 0.3 Nm