Suspension Control Module: Testing and Inspection

Replacing and Coding Control Module Access or Programming Control Position with VAS 5051B

Special tools, testers and auxiliary items required

• Vehicle Diagnostic, Testing and Information System (VAS 5051B) with corresponding diagnostic cable.

If testing equipment is needed on road tests, follow the information below:





CAUTION!
Distraction and testing equipment that is not secured properly increase the risk of an accident.

The passenger airbag could be dangerous if it deploys during an accident.

• Operating testing equipment while driving is a distraction.

• Testing equipment that is not secured probably increases the risk of injury.

• Move the passenger seat as far back as possible.

• Only use the vehicle diagnosis and service system (VAS 5052) or diagnostic system (VAS 5053).

• Testing equipment - 1 - must lie flat on the passenger's lap as shown in the illustration and must only be operated by that passenger.

- Connect (VAS 5051B) with corresponding diagnostic cable to vehicle.

- Switch (VAS 5051B) on.

(VAS 5051B) is ready to operate when it displays operating modes in button fields.

- Switch on ignition.

- Touch Guided Functions on screen.

Then:

- 14 - Electronic damping control module J250

- 14 - Code control module (repair group 40)

or

- 14 - Replace control module (repair group 40)

or

- 14 - Reprogram control position (repair group 40)