Suspension Control Module: Service and Repair

Electronic Damping Control Module

Special tools, testers and auxiliary items required

• Vehicle Diagnostic, Testing and Information System (VAS 5051B)

Removing





The electronic damping control module (J250) is behind the rear shelf (coupe) or bulkhead trim (Spyder) on the right vehicle side.

- Remove the rear shelf in the coupe.

- Remove the right bulkhead trim in the Spyder.

- Remove bolts - 1 -.

- Remove nuts - 2 -.

- Disconnect the connector - 2 - and remove the control module - 1 - to the side.





Installing

Installation is the reverse of removal, with special attention to the following:

- Install the rear shelf or bulkhead trim.

- If the electronic damping control module is replaced, the control position must be reprogrammed.

- Readapt control position using the (VAS 5051B).