Right Rear Connector Station

Right Rear Connector Station

Removing





- With ignition switched off, disconnect battery ground wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the rear shelf.

- Disconnect electrical connectors - 6 through 9 -.

- Remove the positive wire - 4 - on the connector station - 1 -.

- Remove the nuts - 2 and 5 -.

- Unclip the corresponding connector base.

- Remove the ground wire - 3 - on the back of the connector station.

• Check the exact right rear connector station assignment in the current wiring diagram.

Installing

• Tightening specifications, refer to => [ Rear Relay Carrier and Fuse Panel Assembly Overview ] Rear Relay Carrier and Fuse Panel Assembly Overview and => [ Electrical wires to right rear
connector station, tightening specifications ] Rear Relay Carrier and Fuse Panel Assembly Overview

Install in reverse order of removal, observing the following:

- Install the rear shelf.

- Connect battery. Required actions => [ Connecting ] Battery, Disconnecting and Connecting.