Fuse Panel, Right A-Pillar

Fuse Panel, Right A-Pillar

Removing

- With ignition switched off, disconnect battery ground wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the glove compartment.

- Remove the right A-pillar trim.

- Fold the carpet back in the A-Pillar area.

- Release the retaining tab - 2 - and fold the cover cap - 1 - to the side - arrow -.





- Remove the nut - 4 - for the engine compartment battery wire.





- Remove the wiring harness nuts - 1 and 3 -.

- Remove the nuts - arrows - for the fuse panel - 2 -.

- Remove the fuse panel on the A-pillar.

• Check the exact assignment for fuse panel in the current wiring diagram.

Installing

• Tightening specifications, refer to => [ Front Relay Carrier and Fuse Panel Assembly Overview ] Front Relay Carrier and Fuse Panel Assembly Overview and => [ Electrical wire to right A-pillar
fuse panel, tightening specifications ] Front Relay Carrier and Fuse Panel Assembly Overview

Install in reverse order of removal, observing the following:

- Install the right A-pillar trim.

- Install the glove compartment.

- Connect battery. Required actions => [ Connecting ] Battery, Disconnecting and Connecting.