Front ABS Wheel Speed Sensor

Front ABS Wheel Speed Sensor





1 Right Front ABS Wheel Speed Sensor (G45)/Left Front ABS Wheel Speed Sensor (G47)

2 Bolt

• 8 Nm

• The sensor ring/disc is installed in the respective wheel bearing unit and cannot be replaced.

Removing

- Raise vehicle.

- Remove wheels.

- Remove the brake caliper. Refer to => [ Brake Caliper ] Rear Brakes, With Steel Brakes.

• Do not let the brake caliper hand from the brake hose, but secure it to the body with suitable cable ties or wire.

- Release connector - 1 - on speed sensor and disconnect.





- Remove bolt - 2 -.

- Remove the speed sensor - 1 - from the wheel bearing housing.

Installing

Installation is the reverse of removal, with special attention to the following:

- Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650.

- Install the brake caliper. Refer to => [ Brake Caliper ] Front Brakes, With Steel Brakes.

- Turn the steering completely left and right, making sure that the speed sensor wiring has sufficient clearance.

- Install the wheels.

- Lower the vehicle.