Secondary Air Injection Sensor 1, Checking

Secondary Air Injection Sensor 1, Checking

Special tools, testers and auxiliary items required

• Multimeter.

• Wiring diagram.

Test requirements

• The Engine Control Module (ECM) (J623) fuses OK.

• The battery voltage at least 12.5 V.

• All electrical consumers switched off (radiator fan must NOT run during test).

• A/C switched off.

• The ignition switched off.

Procedure

Checking voltage

- Disconnect the Secondary Air Injection Sensor 1 (G609) electrical harness connector - 17 -.





- Switch the ignition on.

- Using a Multimeter, check the Secondary Air Injection Sensor 1 (G609) for voltage.









- Switch the ignition off.

If the specified values are obtained:

- Replace the Secondary Air Injection Sensor 1 (G609).

If the specified values are not obtained:

Checking wiring

If the manufacturers test box is being used, perform the following step.

- Install the test box. Refer to appropriate repair information.

If the manufacturers test box is not being used, perform the following step.

- Remove the Engine Control Module (ECM) (J623). Refer to appropriate repair information.

- Using a Multimeter, check the Secondary Air Injection Sensor 1 (G609) electrical harness connector terminals to the Engine Control Module (ECM) (J623) electrical harness connector T94 terminals for an open circuit.









Specified value: 1.5 ohms Max.

If the specification is not obtained:

- Check the wiring for a short circuit to each other, Battery (+), Ground (GND), or an open circuit.

- Check the electrical harness connector for damage, corrosion, lose or broken terminals.

- If necessary, repair the faulty wiring connection.

If no malfunction is detected in the wiring:

- Replace the Engine Control Module (ECM) (J623). Refer to appropriate repair information.

- Install the intake manifold. Refer to appropriate repair information.

Final procedures

After repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] Diagnostic Modes 01 - 0A.

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] Diagnostic Modes 01 - 0A.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] Monitors, Trips, Drive Cycles and Readiness Codes.