Oil Temperature Sensor/Switch: Service and Repair

Oil Temperature Sensor 2

Removing

- Remove the upper section of the intake manifold.





- Disconnect electrical connectors - 1 - and - 2 -.





- Remove the bolts - arrows - and move the bracket and the EVAP system purge regulator valve 2 (N333) and secondary air injection solenoid valve (N112) to the side.

- Disconnect electrical connector - arrow -.





- Remove oil temperature sensor 2 (G664).

Installing

• Tightening specifications, refer to => [ Upper Engine Oil Cooler, Oil Check Valves and Spray Nozzle Valve Assembly Overview ] Upper Engine Oil Cooler, Oil Check Valves and Spray Nozzle Valve Assembly Overview.

Installation is in reverse order of removal, note the following:

• Replace O-rings.

- Install the upper section of the intake manifold.