Parking Brake Pressure Switch
Parking Brake Pressure Switch
Special tools, testers and auxiliary items required
• Trim Removal Wedge (3409)
Removing
- Remove rear center console.
- Bring seats into rearmost seat position.
- On vehicles with automatic transmission, place selector lever in position S.
- Switch off ignition and remove ignition key.
- Reach from bottom into recesses into recesses at climatronic control module (J255) (control head).
- Pull climatronic control module (control head) out of mounting frame - arrows -.
- Put climatronic control module (control head) down on center console on rag to prevent surfaces from damage.
- Disconnect electrical harness connectors in sequence - A through D - by releasing catches - F -.
- Disconnect electrical harness connector - E -.
- Remove gap cover above ashtray - arrow -.
- Open front ashtray.
- Remove the front ashtray insert.
- Remove bolts - 1 - and - 2 -.
- Release ashtray - 3 - to do so using a screwdriver - arrow -, attach screwdriver at opening - 4 -.
- Remove housing of front ashtray.
- Disconnect electrical harness connector, if present.
- Unclip boot - 1 - for gearshift lever or selector lever on both sides and pull off upward - arrows -.
Vehicles with Automatic Transmission
- Release retaining spring - 2 - and remove selector lever transmission range position display unit (Y26) - 1 - upward.
- Disconnect connector.
All
- Remove screws - arrows -.
- Slightly lift front center console - 1 - at rear and pull off of instrument panel toward rear.
- Disconnect connectors.
- Remove screws - arrows -.
- Carefully release clips - 1 through 3 - and - 6 - at decorative frame - 5 - using a small screwdriver.
- Remove decorative frame with multimedia system control head (E380) - 4 - upward from front center console.
- Remove screws - arrows -.
- Remove parking brake pressure switch (F234) - 1 - at the switch trim.
Installing
Install in reverse order of removal, observing the following:
- Install rear center console.
Tightening Specifications
