Clutch, Luk

SAC Pressure Plate
Tighten bolts M6 13 Nm
Tighten bolts M7 20 Nm
Loosen and tighten one after another in 90° increments

When installing, tighten bolts as follows so pressure plate does not distort (causing shuddering on acceleration)

- Screw in all 6 bolts evenly, by hand, until the bolt heads contact the pressure plate

- Tighten all 6 bolts clockwise, one after the other and in steps of 90° (1/4 turn) until the housing contacts the flywheel

- Tighten all 6 bolts clockwise, one after the other to tightening specification.