Front Door Adjusting

Front Door Adjusting





Panel gap dimensions

• Rear door must be adjusted.

• Panel gap dimensions can be checked using 3371 adjustment gauge.

• Dimension - A - = 3.5 mm ± 0.5mm dimension

• - B - = 4.5 mm ± 0.5mm

• Dimension - C - = 3.5mm ±0.5mm

• Dimension - D - = 0mm +1mm

• The course of the gap must not deviate more than 0.5 mm from parallel.

- Loosen bolts - 1 -.





- Use the markings (arrows - a - and arrows - c -) for side adjustment.

- Slide striker - 2 - until the door is flush with the contour of the chassis.

- Gasket - 3 - must always be replaced.

• Door may only be adjusted for depth (towards car interior) and not for height.

- Use the markings (arrows - b - and arrows - d -) for height adjustment.

- Striker must align in door lock center for correct adjustment.

- Tighten bolts to 25 Nm.