Selector Shaft Lever

Selector Shaft Lever

Special tools, testers and auxiliary items required

• Pry lever (80-200)

Removing:

- Remove screws and remove rear noise insulation - 2 -.





- Pry out selector lever cable ball head - 2 - from selector shaft lever using Pry Lever (80-200).





- Drive out roll pin - 1 - at selector shaft lever - 2 - in direction indicated - arrow - until selector shaft lever can be pulled off selector shaft.





Installing

Install in reverse order of removal, note the following:

- Drive spring pin back onto removed selector shaft lever in opposite direction to lever.

- Slide selector shaft lever onto selector shaft, align and drive in spring pin.

• Selector shaft lever must not be bent when pressing selector lever cable on, counterhold if necessary.

- Carefully press selector lever cable - 2 - onto selector shaft lever without bending lever.