Procedures

Input Shaft Adjustment, Air Gap, Checking

CAUTION!
Do not allow engine to run without filling ATF and do not tow the vehicle.

• ATF filled

- Drive vehicle off hoist.

• On vehicles with air suspension, vehicle lifting mode must be deactivated.

• ATF filled

- Place vehicle on level surface.

• With parking brake released, vehicle may roll forward or backward by itself when in selector lever position "N".

- Start engine.

- Place selector lever in position "N".

• Do not engage parking brake.

• Do not operate brake pedal.

- Press accelerator.

• Vehicle should not be allowed to roll.

If vehicle rolls in selector lever position "N ":

- Adjust selector lever cable.

If selector lever cable adjustment is OK but vehicle still rolls in selector lever position "N":

- Input shaft, servicing => [ Input Shaft, Servicing with 6 Lining Discs ] Input Shaft, Servicing With 6 Lining Discs or => [ Input Shaft, Servicing with 7 Lining Discs ] Input Shaft, Servicing With 7 Lining Discs

• In this case, input shaft adjustment (air gap) was not performed correctly.

If vehicle does not roll in selector lever position " N":

The input shaft adjustment with evaluation of air play is OK.

- Carry out ATF flush => [ First test run pass through: ] ATF Flush