6 SPD. M/T 0A3 AWD

Clutch Pedal Switch F36, removing and installing - 6 Spd. Manual Transmission 0A3 All Wheel Drive

Note:
^ Clutch Pedal Switch F36 may only be installed once so as to ensure a firm fit.

Removing

- Remove storage compartment on drivers side.





- Disconnect electrical connector - 1 - on clutch pedal switch.

^ The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod - arrow - of the Clutch Pedal Switch F36 should then rest against the clutch pedal.

- Release Clutch Pedal Switch F36 - 2 - by turning 45 degrees counterclockwise and take out of guide.

Installing





Installation is performed in reverse of removal; note the following:

- Pull out operating rod - arrow - all the way before installing Clutch Pedal Switch F36.





^ The clutch pedal should be in the normal position (i.e. not pressed down).

- Guide Clutch Pedal Switch F36 through mounting hole, press against clutch pedal and attach by turning 45 degrees clockwise.
- Connect connector for Clutch Pedal Switch F36.
- Install storage compartment on drivers side.

Clutch Pedal Starter Interlock Switch F194, removing and installing

Note:
^ To ensure a secure fit, the Clutch Pedal Starter Interlock Switch F194 must not be installed more than once.

Removing

- Remove storage compartment on drivers side.





- Disconnect electrical connector - 3 - on clutch pedal switch for engine start.
- Press clutch pedal - 1 - all the way down and hold it in this position.
- At the same time, release Clutch Pedal Starter Interlock Switch F194 - 2 - by turning it 45 degrees in the direction indicated - arrow - and pull it out of the guide.





Installing

- Pull out operating rod - arrow - all the way before installing clutch pedal switch.





- When installing Clutch Pedal Starter Interlock Switch F194, press clutch pedal - 1 - all the way down - arrow A -. Hold clutch pedal in this position.
- Guide Clutch Pedal Starter Interlock Switch F194 - 2 - through opening in retainer, and at the same time push operating rod against clutch pedal and secure switch by turning it 45 degrees in the direction indicated - arrow B -.
- Attach electrical connector - 3 - on clutch pedal switch for engine start.
- Install storage compartment on drivers side.