Lock Carrier Service Position Overview

Lock Carrier Service Position Overview

Move lock carriers to service position, refer to => [ Lock Carrier, Placing in Service Position ] Lock Carrier Service Position





1 50 Nm

2 Support Support Tool (3369)

• Tighten to 10 Nm

3 10 Nm

4 10 Nm

5 10 Nm

6 10 Nm

7 Support Support Tool (3369)

• Tighten to 10 Nm

8 50 Nm

Lock Carrier, Placing in Service Position

Special tools, testers and auxiliary items required

• Support Tool (3369)





- On vehicles with auxiliary heater, screw out bolts - arrows - for exhaust pipe of auxiliary/additional heater at noise insulation.





- Unfasten quick-release fasteners - 1 -, screw out bolts - 2 - and detach noise insulation.





- Remove front bumper. Refer to Front Bumper.

- Detach cover - 1 - on left of engine compartment.





- Take the electrical connections - 1 - and - 2 - from the holder.





- Open lines to lock carrier.

- Detach cover - 1 - on right of engine compartment.





- Detach the Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80- 1 at the air ducting.





- Remove screws - arrows -.

- Remove air duct - 2 -.

- Remove air duct on the left - arrow - in front of the auxiliary radiator.





- Remove air duct on the right - arrow - in front of auxiliary radiator.





- Remove screws - arrows - at the left and right of the lock carrier.





- Remove hood seal at lock carrier and at fender edges.

- Screw in Support Tool (3369) on left and right into empty holes.





- Remove screws at impact absorbers - arrows - on left and right.

- Carefully pull lock carrier forward.

Installing

Install in reverse order, paying attention to the following:

- Install lock carrier with attachments: => Radiator Support Radiator Support

- Allow torque reaction support to settle on rubber buffer stop for torque reaction support and tighten bolts - arrows - to 28 Nm.





- Install front bumper.

- Adjust headlights.

Tightening Specifications