Oil Pump and Oil Pan Assembly Overview
Oil Pump and Oil Pan Assembly Overview
1 5 Nm
• Fastened to intake manifold
2 Oil Dipstick
3 Guide Tube for Oil Dipstick
4 Cylinder Block
5 Oil Return Valve
• Note installation position
6 8 Nm
7 Oil Pump Drive Cover
8 O-ring
• Replace
• Oil to install
9 Oil Pump Drive
10 Intermediate Shaft
11 Thrust Washer
12 10 Nm
• Insert with locking compound; Locking compound.
13 Oil Spray Jet for Piston Cooling
• For crankshaft bearing 2 to 7
• Opening pressure 2.0 bar pressure
14 Oil Pump Driveshaft
15 Oil Pump
• Disassembling and assembling, refer to => [ Oil Pump Assembly Overview ] Oil Pump Assembly Overview
• Coat the oil pressure tube on the cylinder block and oil pump housing with sealing paste; sealing paste
16 23 Nm
17 Oil Drain Plug - 30 Nm
18 Oil Pan
• Removal and installation, refer to => [ Oil Pan ] Oil Pan
19 Oil Level Thermal Sensor (G266)
20 Bolt
21 Oil Filter Housing
• Component overview, refer to => [ Oil Cooler and Oil Filter Housing Assembly Overview ] Oil Cooler and Oil Filter Housing Assembly Overview
• Removal and installation, refer to => [ Oil Filter Housing ] Oil Filter Housing
Oil Pan - Tightening Specifications and Tightening Sequence
- Tighten bolts in 3 stages as follows:
- Pre-tighten the bolts connect the oil pan to the cylinder block in a diagonal sequence to 5 Nm.
- Tighten oil pan to transmission connection - arrows - bolts.
- Tighten oil pan to cylinder block connection bolts diagonally to 12 Nm.
• Ignore - 1 -.
Oil Return Valve, Removing and Installing
- To remove, turn bolt M8x1.5 approximately 4 turns in valve - arrow - and remove valve.
- To install, coat O-ring with oil and press valve by hand into oil channel.
Oil Spray Nozzle, Removing and Installing
• The oil spray jets are installed into crankshaft bearings 2 to 7.
- To remove oil spray jets, press out with a drift dia. 4 mm toward crankshaft bearing.
- To install oil spray jets, press in by hand using a drift dia. 6 mm - arrow -.
Oil Level Thermal Sensor (G266), Removing and Installing
1. Bolt - 10 Nm; self-locking, replace
2. Sealing ring; replace
3. Electrical harness connector
4. Oil Level Thermal Sensor (G266)