Balancing Shaft

Balancing Shaft

Removing

- Remove the power take-off drive chain. Refer to => [ Power Take-Off Drive Chain ] Power Take-Off Drive Chain.

- Remove bolts - arrows - and remove balance shaft rear bearing cap.





- Remove bolts - 2 - and - 4 - and remove balance shaft cover.





- Remove bolts - 1 - and - 3 - and remove balance shaft front bearing cap.

CAUTION!
Make sure the oil injection jets are not damaged when balance shaft is removed.

- Carefully remove balance shaft from cylinder block.

Installing

Installation is in reverse order of removal, note the following:

• Replace gaskets and O-rings.

CAUTION!
Make sure the oil spray jets are not damaged when balance shaft is inserted.

- Carefully insert balance shaft in cylinder block.

- Tighten balance shaft rear bearing cap - arrows -.





- Insert balance shaft in rear bearing cap.

- Insert balance shaft front bearing cap - arrow -.





• The bolts for the balance shaft front bearing cap are installed later after the balance shaft is adjusted.

• Balance shaft, adjusting. Refer to => [ Power Take-Off Drive Chain ] Power Take-Off Drive Chain.

- Install the power take-off drive chain. Refer to => [ Power Take-Off Drive Chain ] Power Take-Off Drive Chain.

Tightening Specifications