Hydraulic Lines to Connecting Plate, Removing and Installing

Hydraulic lines to connecting plate, removing and installing

Special tools, testers and auxiliary items required







- Hydraulic Line Connect Tool 3335







Removing
Follow cleanliness rules.
Hydraulic pump connection table.
- Remove hydraulic pump.
- Remove center and side bulkhead trim.







- Raise spring washer - 1 - on hydraulic lines to be removed (supply and return) over collar on connecting piece with a small screwdriver and remove.







Installing
- Place hydraulic line with connecting piece through connecting plate.
- Place Hydraulic Line Connect Tool 3335 sleeve - 1 - over connecting piece.
- Slide spring washer - 2 - onto sleeve and press it on completely with Hydraulic Line Connect Tool 3335.







NOTE: Spring washer - 2 - must slide completely over collar on connecting piece - 1 -.

- Coat sealing ring - 3 - with hydraulic oil and slide it onto connecting piece.







Hydraulic pump connection table
Connections shown from hose side out.
1 - Main drive motor hydraulic cylinder
11 - Left piston rod side
12 - Left piston side
13 - Right piston rod side
14 - Right piston side

2 - Bracket drive motor hydraulic cylinder
21 - Left piston rod side
22 - Left piston side
23 - Right piston rod side
24 - Right piston side

3 - Convertible top compartment cover hydraulic cylinder
31 - Left piston rod side
32 - Left piston side
33 - Right piston rod side
34 - Right piston side