Left and Right Convertible Top Compartment Cover Locks, Removing and Installing

Left and right convertible top compartment cover locks, removing and installing

Removing
- Remove rear seat bench and backrest.

CAUTION: Observe safety precautions when handling pyrotechnic belt tensioners.

- Remove respective rear belt retractor.
- Disconnect electrical connector behind belt retractor.







- Bring convertible top into center position.
- Remove securing clips for front convertible top compartment well trim until compartment locks are accessible.







- Remove locking washer - 1 -.
- Remove push rod - 2 -.
- Mark exact position of bolts - 3 - and remove.
- Remove convertible top compartment cover lock and lay it sideways,
- Disconnect switch unit electrical connector and remove switch and lock.

NOTE: The connection is located behind the belt retractor.

Installing
Installation is reverse of removal, noting the following:
- Install bolts exactly at the markings made earlier. In this way, it is not necessary to adjust the locks.
- Ensure the convertible top compartment cover aligns with the side panel when closed.
- Check whether switch works with convertible top compartment cover closed.