Right Flange Shaft, Removing and Installing

Right flange shaft, removing and installing 02E, 6 Speed Direct Shift AWD A/T





Special tools, testers and auxiliary items required
^ Old oil collecting and extracting device V.A.G 1782
^ Puller T10037
^ Socket and key T10107

Removing

Note:
^ Rules for cleanliness when working on transmission.
^ General repair notes.

- Remove right drive axle.





- Remove right drive axle heat shield from bevel box - arrows -.





- Place used oil collecting and extracting device V.A.G 1782 beneath transmission.
- Remove right flange shaft countersunk screw with socket and key T10107 by installing 2 screws in flange and counter holding flange shaft with assembly lever.





- Remove flange shaft with puller T10037.

Installing
Installation is in reverse order of removal. Note:

Note:
^ Replace flange shaft countersunk bolt.

- Carefully drive flanged shaft, turning while doing so.
- Secure flange shaft with new countersunk bolt.
- Install right drive axle.
- Check oil level in bevel box and top off.

Torque specifications

Torque specifications: