Center Console (Rear Section), Removing and Installing

Center Console (rear Section), Removing And Installing







1 - Rear section of center console
Removing
- Remove rear air vent and rear air-duct connecting piece
- If necessary, remove center armrest.
- Remove nut - 3 -.
- Remove mat lining - 2 - upward.
- Remove bolt - 8 -.
- With manual transmission:
- Twist off shifter knob - 4 -.
- Unclip protective boot - 5 - upward.
- Unclip center console insert - 6 - upward.







- With automatic transmission:
- Unclip center console insert - 6 - upward.
- Remove bolts - 7 - (2x).
- Remove parking brake pry trim
- Raise rear section of center console - 1 - at front and detach connector for mirror adjustment switch - 9 -
- Pull parking brake pry up as far as it will go.
- Unfasten trim - 10 - from retainer - 11 - on parking brake pry.
- Raise rear section of center console - 1 -over stud - 12 - and pull center console to rear.
- Lift out rear section of center console - 1 - forward over parking brake pry.

Installing
- Install trim - 10 - at retainer - 11 - on parking brake pry.
- Make sure air ducts are properly installed when installing rear section of center console - 1 -.

2 - Mat lining







3 - Nut
- Tightening torque: 10 Nm (7 ft lb)
4 - Shifter knob
- Twisted on
5 - Protective boot
- Unclip upward
- Pay attention to position of locking clips when installing
6 - Center console insert
7 - Screws (2x)
- Tightening torque: 5 Nm (44 in.lb)
8 - Screw (1x)
- Tightening torque: 5 Nm (44 in.lb)
9 - Mirror adjustment switch
10 - Parking brake pry trim
11 - Retainer tab
12 - Stud