01V 5 Speed Automatic

5 Speed Automatic 01V

Lock Cable, removing and installing

Required special tools





^ 3352 A Gauge





Removing
- Shift selector lever to "2".
- Obtain radio antitheft code.
- Disconnect battery ground connection.
- Remove handle for selector lever.
- Remove front center console.
- Remove steering wheel.
- Turn ignition key to driving position (ignition on).
- Shift selector lever to "P".
- Lift clip for retainer -1-and pull out lock cable from ignition/starter switch.
- Remove cover with gate (selector lever actuation).
- Unclip lock cable from securing spring at mounting bracket while slightly lifting securing spring.
- Free lock cable from cable tie -2- and remove.

Installing
- Route lock cable without kinks.
- Turn ignition key to driving position (ignition on).
- Insert lock cable in ignition/starter switch.
- Check locking device -1- for proper engagement.
- Attach lock cable with cable tie -2-to airbag sensor.
- Turn ignition/starter key to lock position (ignition off).
- Shift selector lever to "P".
- Clip in lock cable in securing spring of mounting bracket.
- Insert Lock cable bracket -3- in shift mechanism and lock cable eye in lever for lock cable.

Adjusting
- Shift selector lever to "P".
- Loosen bolt -6
- Clamp -3- must be movable by hand in direction of arrow -5-.
- Move steering column to lowest position.
- Insert gage 3352 A item 4 between lever for lock cable and lock cable eye.
- Pull lock cable in direction of arrow -5- and tighten bolt -6- with 10 Nm (7 ft. lbs.).
- Remove adjustment gage.
- Check ignition key removal lock after every adjustment of the lock cable.
- Install steering wheel.
- Install front center console
- Install handle for selector lever
- Reconnect battery ground cable.
- For vehicles with theft protected radio reactivate code.