Connector Locations

Engine Coolant Temperature (ECT) Gauge Sensor G2 - 3.0L 6-cylinder Engine, Multi-pin Connector Assignments

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

Preparations







- Remove rear engine cover - arrows -.







- Remove bolts for solenoid valve retaining plate - 3 - - arrows -.
- Remove air intake hose - 1 - at mass air flow (MAF) sensor G70.
- Remove hose - 4 - at air duct - 2 -.







- Remove bolt - arrow - and pull off air duct - 2 - at throttle valve control module J338.
- Where applicable, remove hose - 1 - at air duct.

NOTE: For illustration purposes the air duct is shown from the rear with the engine removed.







- Disconnect electrical connection - 2 - at sensor.

NOTE: Disregard - 1 -.







Pin assignment for 4-pin connector at engine coolant temperature (ECT) gauge sensor G2
1. Wiring from sensor to instrument cluster (temperature gauge)
2. Ground (GND) ( - )