Adjusting Gearset, Recommended Sequence

Adjusting gearset, recommended sequence, 01X, 6 Spd. M/T FWD





The following work sequence is recommended to save time when crown wheel and pinion shaft have to be adjusted:
^ Determine total shim thickness "Stotal" (S3 Plus S4) for the specified preload on pinion shaft tapered roller bearings.
^ Distribute total shim thickness "Stotal" (S3 Plus S4) so that dimension from center of crown wheel to end face of pinion shaft corresponds to installation dimension R determined during production.
^ Determine total shim thickness "Stotal" (S1 Plus S2) for the specified preload on differential tapered roller bearings.
^ Distribute total shim thickness "Stotal" (S1 Plus S2) so that the specified backlash between crown wheel and pinion shaft is obtained.