Adapter Cable For HID Headlamp Bulb Control Module, Removing and Installing

Adapter Cable For HID Headlamp Bulb Control Module, Removing And Installing

CAUTION:
- HIGH VOLTAGE!
- Always disconnect negative (-) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH VOLTAGE" warning symbols.

Removing
- Remove headlamp.







- Remove screws - 1 - and - 2 -.
- Release retaining clip - 3 - in direction of - arrow - and detach housing cover from headlamp housing.







- Remove screws - arrows -.
- Remove control module - 1 - from housing cover for headlamp housing.







- Disconnect electrical connection -1 -.

NOTE: Disregard - 2 -.







- Disconnect electrical connection - 4 - at HID headlamp bulb.
- Remove wiring - 1 - and adapter cable - 3 - from retainer - 2 -.
- Guide adapter cable out of housing cover - 5 -.

Installing
Install in reverse order of removal, noting the following:
- Insert adapter cable and electrical wiring in retainer.
- Check gasket between control module for gas discharge lamp and headlamp housing.
- Install headlamp.
- Reconnect battery. Required steps.

Tightening torque

Component - fastener Nm
Control module to headlamp - screw 1