Fuel Delivery Unit, Removing and Installing

Fuel Delivery Unit, Removing And Installing

Special tools, testers and auxiliary items required







- Wrench 3087

Removing

CAUTION:
- To remove the fuel delivery unit, the fuel tank may only be filled to a maximum of 1/4. Drain fuel tank if necessary. Procedure Fuel tank, draining.
- Observe procedures for disconnecting battery.







- Push cover over battery toward right - arrow 1 - and remove it upward - arrow 2 -.







- With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.
- Open fuel filler flap briefly and then close again.







- Remove rear seat bench Body Interior -.
- Unbolt cover for right locking flange - arrows -.







- Disconnect electrical harness connector - arrow - at right locking flange.







- Mark fuel return line -1- and fuel supply line -2-.

CAUTION: The fuel system is under pressure. Before opening system, place rags around the connection area. Then release pressure by carefully loosening the connection.

- Pull both lines from locking flange, by pressing release buttons.

CAUTION: Locking flange may only be opened when fuel tank is maximum 1/4 full. Otherwise, a large amount of fuel will spill out.







- Remove locking ring using wrench 3087.
- Remove locking flange and seal from opening in fuel tank and lay aside locking flange with lines still connected.







- Disconnect suction jet pipe -1- to suction jet pump by pressing release button.
- Disengage fuel delivery line -2-.
- Remove fuel delivery unit.

NOTE:
- When removing fuel delivery unit, be sure not to bend floater arm of Fuel Level Sensor G.
- Be aware that fuel is still in the fuel delivery unit.

Installing
Installation is in reverse order of removal. Note the following:

NOTE:
- Replace seal.
- When inserting fuel delivery unit, be sure not to bend Fuel Level Sensor G.
- Make sure fuel hoses are seated securely.

- Insert fuel delivery unit into fuel tank with locking flange set aside.
- Attach fuel delivery line -2-.
- Push suction jet pipe -1- onto suction jet pump until it engages audibly.







Make sure fuel hoses are routed correctly:
- The fuel supply line -1- must be routed between guide tube -4- and supports -2- for fuel return line. Also, it must be routed around outside of guide tube -3-.

- Insert guide tubes -3- and -4- of locking flange into guide holes - arrows - of fuel delivery unit.

NOTE: To improve clarity, the fuel delivery unit is shown without the fuel tank.







- Install new locking flange seal dry.
- Press locking flange down against spring pressure and bring it into installation position.

- Tab -2- on locking flange must lie between tabs -1- and -3- on fuel tank.







- Tighten locking ring.
- Connect battery. Observe safety precautions after connecting battery Electrical Equipment -.

Torque specifications

Component Nm
Locking ring for fuel delivery unit 145