Right Combination Valve For Secondary Air Injection, Removing and Installing

Right Combination Valve For Secondary Air Injection, Removing And Installing

Removing







- Remove rear engine cover (arrows).







- Remove cover -1- in engine compartment (right side).







- Remove bolts for holding plate -3- for solenoid valves (arrows).
- Disconnect intake air hose -1- at Mass Air Flow (MAF) sensor.
- Disconnect hose -4- for crankcase ventilation from air guide -2-.







- Remove bolt (arrow) and disconnect air guide -2- at throttle valve control module.
- Disconnect hose -1- from air guide.

NOTE: The illustration shows the air guide from the rear with the engine removed.







- Unscrew bolts -1- and -2- and remove combination valve.
- Disconnect vacuum hose (arrow).

Installing
Installation is reverse of removal, noting the following:

NOTE: Replace gaskets and O-rings.

Tightening torques

Component Nm
Combination valve to cylinder head 10
Connecting tube to combination valve 10