Selector Mechanism, Disassembling and Assembling

Selector mechanism, disassembling and assembling, 01J, CVT A/T FWD

Disassembling





Note:
^ Securing spring for locking cable, removing and installing.

6 - Selector lever
- Shift selector lever in position D.
- Remove shift lock solenoid -7-.
- Unclip selector lever guide -12-.
- Release pivot pins -5- and -19- and pull them out from the side.
- Unclip retaining brackets -2- and -16-
- Pull off retaining clip -17-.
- Swing locking lever -11- upward as far as it will go.
- Pull selector lever -6- together with bushings -3- and -15- as well as Tiptronic locking levers -4- and -18- downward out of selector housing -14-.

Assembling





6 - Selector lever
- Check that selector lever is in position D.
- Swing locking lever -11- upward as far as it will go.
- Insert selector lever -6- from below into selector housing -14-.
- Connect locking levers for Tiptronic -4- and -18- as well as bushings -3- and -15- on selector lever.
- Press selector lever -6- with bushings into selector housing and position it with retaining clip -17-.
- Engage retaining brackets -2- and -16- on selector housing.
- Push pivot pins -5- and -19- into selector lever -6- until they engage.
- Check whether pivot pins engage in locking lever for Tiptronic.
- Install shift lock solenoid -7-.
- Clip in shift gate -12-.





Removing and installing securing spring for locking cable

Removing:
- To remove locking cable, lift spring slightly at top -arrow B-.
- Disengage spring at retaining tab -arrow C- and remove upward.

Installing:
- Insert spring -arrow B- from above and engage retaining tab -arrow C-.
- Align spring so that it is seated evenly in groove -arrow A-.