Selector Lever Cable and Locking Cable, Assembly Overview

Selector lever cable and locking cable, assembly overview, 01J, CVT A/T FWD





Note:
^ Do NOT bend or kink selector lever cable.
^ Lightly grease eyelet and ball socket with polycarbamide grease G 052 142 A2 before installing.

1 - 23 Nm
2 - Selector lever cable
^ Do not bend or kink, lightly grease coupling ring and ball socket before installing
^ Removing and installing
^ Adjusting
^ Selector lever cable must be replaced if rubber sleeves are damaged
^ When installing, make sure that rubber sleeve on transmission side is not twisted

3 - Lock nuts, 12 Nm
4 - Boot for selector lever cable
^ Fasten into bottom cover of shift mechanism

5 - Retaining clip
6 - Ignition/starter switch
^ With ignition key removal lock

7 - Locking cable
^ For ignition key removal lock
^ Must not be kinked
^ Removing and installing
^ Adjusting

8 - 9 Nm
9 - Clamping screw, 13 Nm
^ For selector lever cable
^ To adjust, loosen by approximately 1 turn, do not fully remove

10 - Pin
^ For selector lever cable
^ To remove selector lever cable, pull plastic locking spring on shift mechanism forward slightly and push pin up only as far as necessary

11 - Retaining clip for selector lever cable
12 - Support bracket for selector lever cable
13 - 23 Nm
14 - Bracket for selector lever cable