Differential Output Shaft: Service and Repair

Right flange shaft, removing and installing, 01J, CVT A/T FWD

Special tools, testers and auxiliary items required
^ Drip tray

Removing
^ Transmission installed.

- Remove right front wheel.





- For vehicles with auxiliary heater, remove bolts -arrows- for exhaust pipe of parking heater/auxiliary heater on sound insulation.





- Remove bolts or quick-release fasteners -1 to 3- and remove front and rear sound insulation.





- Where installed, remove bolt -1- for sound insulation cover over right drive axle.
- Disengage hook -2- and remove sound insulation cover.
- Remove heat shield for right drive axle.
- Remove right drive axle.





- Remove mounting bracket for flange shaft -arrows-
- Place an Drip tray underneath transmission.
- Pull out right flange shaft together with mounting bracket.

Installing
- Clean flange shaft.
- A damaged sealing ring must be replaced.





- Replace O-ring -arrow A- in mounting bracket for flange shaft.
- Slide spring -C- with cap outward into hole on end of flange shaft -arrow-.
- Insert flange shaft -B- into transmission housing.

Note:
^ While sliding in the flange shaft, make sure that spring -C- remains in the flange shaft and does not fag into transmission.





- Tightly bolt mounting bracket for flange shaft -arrows-.
- Install right drive axle.
- Check gear oil level in front final drive.

Tightening Torque: