Lock Carrier In Service Position, Overview

Lock carrier in service position, overview

Special tools and equipment

Special tool 3369:

Lock carrier in service position





1. 45 Nm
2. 45 Nm
3. 10 Nm
4. 10 Nm
5. Hole
^ For special tool 3369
6. Hole in lock carrier
7. Hole in fender

Removing
Vehicles with auxiliary heater





- Remove bolts (arrows) securing exhaust pipe of auxiliary/additional heater to sound insulation.

All models





- Remove sound insulation (arrows).





- Remove bolts (arrows).
- Disengage EVAP canister purge regulator valve -N80 -1- from air duct.
- Remove air duct -2-.
- Pull off hood seals at lock carrier and fender edges.
- Remove front bumper:





- Remove bolts on left and right (arrows).





- Screw special tool 3369 into free holes on left and right.
- Remove bolts on left and right (arrows).
- Carefully pull lock carrier forward.

Installing
Install in reverse order, paying attention to the following:
- Bolt lock carrier to longitudinal member (50 Nm) and to fenders (10 Nm).





- Allow stop for torque reaction support to rest on rubber buffer for torque reaction support under its own weight, and tighten bolts (arrows) to 28 Nm.
- Install front bumper:
- Adjust headlights:

Tightening torques

Tightening torques: