5 Speed Automatic 01V

5 SPD. A/T 01V

Wiring harness in transmission, removing and installing
Removing
^ Remove valve body.

^ Using a small screwdriver, pry out retaining tabs on solenoid valve connector and pull off harness connectors -A- one after the other.
^ Disengage wiring harness from retainers -13- on side of valve body.

Only for transmissions with hydraulic control E17

^ Turn valve body over, and disconnect connector from sensor for transmission RPM -1-.
^ Remove retaining clip (arrow -A-) and unclip wiring harness from retaining clip (arrow -B-).

Installation valid for all:
Installation is the reverse order of removal, noting the following:
^ Connect connectors of wiring harness to respective solenoid valves and sensors when installing.
^ Clip wiring harness into the intended retaining clips. The wiring harness can be pinched during installation in case of variations.
^ Install valve body.
^ Fill up ATF.