Overview of Removed Components For Transmissions With Hydraulic Control E18/2
5 SPD. A/T 01V
Overview of removed components for transmissions with hydraulic control E18/2
1. Drain plug - 40 Nm (30 ft. lbs.)
^ 5 mm hex socket
^ Remove to drain ATF
2. Seal
^ Always replace
3. Bolt - 10 Nm (7 ft. lbs.)
^ Tighten bolts for oil pan diagonally in several stages
4. Oil sump
5. Gasket
^ Always replace
6. Oil strainer
7. Bolt - 8 Nm (70 inch lbs.)
^ For attaching valve body: 1 bolt M6 x 30, 16 bolts M6 x 60
^ Note tightening method sequence
8. Valve body
^ Allocation according to transmission code; Refer to Parts Catalog
9. Bolt - 8 Nm (70 inch lbs.)
10. Bracket
^ For wiring harness
^ Insert wiring harness
^ Attached with bolts for valve body
11. Bolt - 6 Nm (53 inch lbs.)
12. Transmission Vehicle Speed Sensor -G38-
13. Spacer sleeve
^ Height: 8 mm
14. Inner oil line
^ Replace
15. O-ring
^ Always replace
16. Speedometer Vehicle Speed Sensor -G22-
17. O-ring
^ Always replace
^ Coat with Vaseline
18. Multi-Function Transmission Range Switch -F125-
^ Replacing seal for shift rod
19. Bolt - 8 Nm (70 inch lbs.)
20. O-ring
^ Always replace
21. Securing clip
22. Wiring harness
^ Transmission Fluid Temperature Sensor -G93- integrated in wiring harness
^ To replace, remove and install valve body.
^ Release from bracket for wiring harness -item 10-
^ Installation position of wiring harness connector: flat point of rear shoulder faces oil pan, the lugs on the shoulder are horizontal
23. Bolt - 9 Nm
24. Transmission Input Speed Sensor -GI82-
25. Spacer sleeve
^ Is connected in wiring harness in transmission.
^ Must be disconnected before removing valve body.
26. Screw - 6 Nm (53 inch lbs.)
27. Bracket
^ For solenoid valve
28. Solenoid Valve 4 -N91-
^ With O-ring
^ To replace, remove and install valve body
29. Solenoid Valve 3 -N90
^ Without O-ring
^ To replace, remove and install oil pan
30. Solenoid Valve 2 -N89-
^ Without O-ring
^ To replace, remove and install oil pan
31. Screw - 6 Nm (53 inch lbs.)
32. Bracket
^ For solenoid valve
33. Solenoid Valve 6 -N93-
^ With O-ring
^ To replace, remove and install oil pan
34. Solenoid Valve 7 -N94-
^ With O-ring
^ To replace, remove and install oil pan
35. Solenoid Valve 5 -N92-
^ With O-ring
^ To replace, remove and install oil pan
36. Solenoid Valve 1 -N88-
^ Without O-ring
^ To replace, remove and install oil pan and unbolt guide plate for park lock mechanism
^ When installing, do not tighten bolts for guide plate (23 Nm) when selector lever is in position "P"
37. Bolt - 6 Nm (53 inch lbs.)
38. Magnet
^ 4 magnets in the beads of oil pan
39. O-ring
^ Always replace
40. ATF filler plug - 80 Nm (59 ft. lbs.)
^ 17 mm hex socket