Overview of Removed Components For Transmissions With Hydraulic Control E17
5 SPD. A/T 01V
Overview of removed components for transmissions with hydraulic control E17
1 - 2. Drain plug - 40 Nm (30 ft. lbs.)
^ 5 mm hex socket
^ Remove to drain ATF
3. Seal
^ Always replace
4. Bolt - 10 Nm (7 ft. lbs.)
^ Tighten bolts for oil pan diagonally in several stages
5. Oil sump
6. Gasket
^ Always replace
7. Oil strainer
8. Bolt - 8 Nm (70 inch lbs.)
^ For attaching valve body: 1 bolt M6 x 30, 16 bolts M6 x 60
^ Note tightening method
9. Valve body
^ Allocation according to transmission code; Parts Supplier
10. Bolt - 8 Nm (70 inch lbs.)
11. Bracket
^ For wiring harness
^ Insert wiring harness
^ Attached with bolts for valve body
12. Bolt - 6 Nm (53 inch lbs.)
13. Transmission Vehicle Speed Sensor -G38-
14. Spacer sleeve
^ Height: 8 mm
15. Inner oil line
^ Always replace
16. O-ring
^ Always replace
17. Speedometer Vehicle Speed Sensor -G22-
18. O-ring
^ Always replace
^ Coat with petroleum jelly
19. Multi-Function Transmission Range Switch -F125-
20. Bolt - 8 Nm (70 inch lbs.)
21. O-ring
^ Always replace
22. Locking clasp
23. Wiring harness
^ Transmission Fluid Temperature Sensor -G93- integrated in wiring harness
^ To replace, remove and install valve body
^ Release from bracket for wiring harness -item 10-
^ Location of wiring harness connector: flat point of rear shoulder faces down, the lugs on the shoulder are horizontal
24. Bolt - 6 Nm (53 inch lbs.)
25. Transmission Input Speed Sensor -G182-
26. Spacer sleeve
^ Height: 20 mm
27. Screw - 6 Nm (53 inch lbs.)
28. Bracket
^ For solenoid valve
29. Solenoid Valve 4 -N91-
^ With O-ring
^ To replace, remove and install valve body
30. Solenoid Valve 3 -N90
^ Without O-ring
^ To replace, remove and install oil pan
31. Solenoid Valve 2 -N89-
^ Without O-ring
^ To replace, remove and install oil pan
32. Screw - 6 Nm (53 inch lbs.)
33. Bracket
^ For solenoid valves
34. Solenoid Valve 6 -N93-
^ With O-ring
^ To replace, remove and install oil pan.
35. Solenoid Valve 7 -N94 With O-ring To replace, remove and install oil pan.
36. Solenoid Valve 5 -N92 With O-ring To replace, remove and install oil pan.
37. Solenoid Valve I -N88-
^ Without O-ring
^ To replace, remove and install oil pan and unbolt guide plate for park lock mechanism
^ When installing, do not tighten bolts for guide plate (23 Nm) when selector lever is in position "P"
38. Bolt - 6 Nm (53 inch lbs.)
39. Magnet
^ 4 magnets in the beads of oil pan
40. O-ring
^ Always replace
41. ATF filler plug - 80 Nm (59 ft. lbs.)
^ 17 mm hex socket