Exhaust system components, removing and installing

Exhaust System Components, Removing And Installing


NOTE:
- Aligning exhaust system to relieve stress
- Checking exhaust system for leaks
- Separating point between center and rear mufflers
- Always replace gaskets and nuts







1 - 40 Nm (29 ft lb)
2 - from Three Way Catalytic Converter (TWC)
3 - Carriage bolt
4 - Double clamp
- Tighten evenly to 40 Nm (29 ft lb)
- Installation position
- Always replace clamp after bolts have been loosened
5 - 25 Nm (18 ft lb)
6 - Mount
- With retainer
7 - Center muffler
8 - Repair double clamp
- Tighten evenly to 40 Nm (29 ft lb)
- Installation position
- Always replace clamp after bolts have been loosened
9 - Separating point
- At the factory, center and rear mufflers are installed as single components. Replacement center and rear mufflers are supplied separately with double clamps for connecting the joints.
- Cutting at separating point See Fig. 1
10 - Rear muffler, right
11 - Mount
12 - Bracket
13 - Rear muffler, left

Fig. 1 Separating point between center and rear mufflers







The cutting point between center an rear mufflers is used to replace parts separately if required.

- Cut through connecting pipes between center and rear mufflers at points marked with groove:
- Dimension a = approx. 244 mm (9.6 in.)