Cargo Area Side Trim

Cargo Area Side Trim







1 - Cargo Area Trim

Removing
- Remove cargo area cover.
- Remove rear bench seat.
- Remove respective side padding.
- Detach seat belt from bottom attachment.
- Remove trim plate for seat belt Fig. 1.
- Remove rear cross panel trim.
- Remove screws - 4 - (2x) for fastening rings - 3 -.
- Remove cover - 2 -.
- Remove screw - 6 - (1x).
- Remove bolt - 7 -.
- Unclip trim at rear.
- Pull trim slightly toward the front, and disconnect connector for rear electrical socket.







Installing
- Engage cargo area trim behind side window flange.
- Remainder of installation is carried out in reverse order of removal.
2 - Cover
3 - Fastening rings
4 - Screw (2x)
- Tightening torque: 4.5 Nm (40 in lb)
5 - Mount for cargo area cover
6 - Screw (1x)
- Tightening torque: 2.5 Nm (22 in lb)
7 - Screw (1x)
- Tightening torque: 2.5 Nm (22 in lb)







Fig. 1 Removing and installing trim plate for seat belt
- Using a screwdriver, pry out retaining tabs - 2 - (2x).
- Pull out seat belt trim - 1 - in direction of arrow.
- Guide seat belt out through trim plate - 1 -.