Clutch Switch: Service and Repair
Clutch Pedal Switch F36, removing and installing, 0A3, 6 Spd. M/T AWD
Note:
^ Clutch Pedal Switch F36 may only be installed once so as to ensure a firm fit.
Removing
- Remove storage compartment on drivers side.
- Disconnect electrical connector - 1 - on clutch pedal switch.
^ The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod - arrow - of the Clutch Pedal Switch F36 should then rest against the clutch pedal.
- Release Clutch Pedal Switch F36 - 2 - by turning 45° counterclockwise and take out of guide.
Installing
Installation is performed in reverse of removal; note the following:
- Pull out operating rod - arrow - all the way before installing Clutch Pedal Switch F36.
^ The clutch pedal should be in the normal position (i.e. not pressed down).
- Guide Clutch Pedal Switch F36 through mounting hole, press against clutch pedal and attach by turning 45° clockwise.
- Connect connector for Clutch Pedal Switch F36.
- Install storage compartment on drivers side.
Clutch Pedal Starter Interlock Switch F194, removing and installing
Note:
^ To ensure a secure fit, the Clutch Pedal Starter Interlock Switch F194 must not be installed more than once.
Removing
- Remove storage compartment on drivers side.
- Disconnect electrical connector - 3 - on clutch pedal switch for engine start.
- Press clutch pedal - 1 - all the way down and hold it in this position.
- At the same time, release Clutch Pedal Starter Interlock Switch F194 - 2 - by turning it 45° in the direction indicated arrow - and pull it out of the guide.
Installing
- Pull out operating rod - arrow - all the way before installing clutch pedal switch.
- When installing Clutch Pedal Starter Interlock Switch F194, press clutch pedal - 1 - all the way down - arrowA -. Hold clutch pedal in this position.
- Guide Clutch Pedal Starter Interlock Switch F194 - 2 - through opening in retainer, and at the same time push operating rod against clutch pedal and secure switch by turning it 45° in the direction indicated - arrowB
- Attach electrical connector - 3 - on clutch pedal switch for engine start.
- Install storage compartment on drivers side.