Right Combination Valve For Secondary Air System, Removing and Installing

Right combination valve for secondary air system, removing and installing

Removing





- Remove rear engine cover (arrows).





- Remove air cleaner cover -2-.
- Remove air duct -1 -.

Note: Pull out clips (arrows) using pry lever 80-200.





- Disconnect connector -3- at evaporative emission (EVAP) canister purge regulator valve -N80- item -2-.
- Detach solenoid valve from holder.
- Disconnect connector -4- at mass air flow sensor.
- Turn hose -1- to secondary air pump counter-clockwise and detach.
- Remove air hose -5- at mass air flow sensor.
- Remove bolt (arrow).
- Take out air cleaner housing with mass air flow sensor.





- Remove air hose from throttle valve control part (arrow).





- Disconnect air hose (arrow) to secondary air system combination valves.





- Disconnect connector (arrow) for camshaft position (CMP) sensor G40- at right cylinder head.

Note: Illustration shows engine from rear.





- Remove vacuum hose -3-.
- Remove bolts -1-, -2- and -4- and remove combination valve.

Note: Illustration shows engine from rear

Installing
Install in reverse order, note the following:

^ Note:
^ Replace gaskets.
^ Secure all hose connections with standard hose clamps; Refer to Part Supplier





Tightening torques