Trunk / Liftgate Shock / Support: Service and Repair

Gas-filled Strut For Rear Lid, Removing And Installing

Removing
- Prop up and secure rear lid in open position.







- Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut - 1 - from upper ball stud - 2 -.

NOTE:
- Following complete removal of the gas-filled strut, check for correct positioning during installation.
- Sound insulation component must be installed on the body side.

Installing
Installation is the reverse of removal, noting the following:
- To install, press gas-filled strut onto ball studs so that it engages in position.
- Ball stud tightening torque: 15 Nm(-1 Nm)