Input Shaft, Drive Pinion, Hollow Shaft and Internal Selector.

Input shaft, drive pinion, hollow shaft and internal selector mechanism from bearing plate, removing and installing
1. Bearing plate
^ Servicing, Refer to Bearing Plate, Servicing
2. Selector rod for 5th and 6th gear
^ Only replace complete with follower for 5th and 6th gear, Refer to 5TH and 6TH Gear, Removing and Installing
3. Follower for reverse gear
^ Pulling out ball sleeve, Refer to , Refer to Bearing Plate, Servicing, See Fig. 3
^ Driving in ball sleeve, Refer to Bearing Plate, Servicing, See Fig. 4
4. Selector fork for 3rd and 4th gear
^ Can be replaced individually
^ Installation position: rib towards follower
5. Selector rod for 3rd and 4th gear
^ Only replace complete with follower for 3rd and 4th gear
6. Input shaft
^ Disassembling and assembling, Refer to Overhaul Subassemblies,Input Shaft, Disassembling and Assembling
7. Follower for 1st and 2nd gear
^ Can be replaced individually
8. Circlip
^ Qty.2
9. Selector rod for 1st and 2nd gear
^ Only replace together with selector fork for 1st and 2nd gear (secured together by means of a pin)
10. Hollow shaft
^ Disassembling and assembling, Refer to Overhaul Subassemblies, Drive Pinion and Hollow Shaft, Disassembling and Assembling
11. Drive pinion
^ Disassembling and assembling, Refer to Overhaul Subassemblies, Drive Pinion and Hollow Shaft, Disassembling and Assembling
12. Locking bolts
^ Qty.4
^ For aluminum bolt: 50 Nm
^ For steel bolt: 70 Nm
^ Mark installation positions of aluminum bolts and steel bolts; do not interchange