Shift Mechanism Cover and Selector Lever Handle, Disassembling and Assembling (Overview)

Shift mechanism cover and selector lever handle, disassembling and assembling (overview)

Note: Lubricate bearings and moving parts with polyurea grease, Part No. G 052 142 A2.





1. Selector lever
2. Shaft section for selector lever
3. Selector lever handle
4. Cover
^ With selector scale and Tiptronic gate
^ Removing and installing -Removing Tiptronic switch -F189-,
5. Symbol panel
^ Clipped into cover
6. Printed circuit
^ With integrated Tiptronic switch -F1 89-
^ Switch consists of 3 Hall sensors, which are activated by a magnet on the transverse slide of the roll cover.
^ In the event of malfunctions, check that the magnet is properly secured on the transverse slide of the roll cover -Item 7 replace the cover if necessary.
^ If tester indicates DTC 18161, first check adjustment of selector lever cable before replacing printed circuit
7. Roll cover
^ With integrated magnet for Tiptronic switch -F189- on transverse slide
8. Guide
^ Guides roll cover
^ Carefully pry apart the two halves