Bearings For Torsen Differential, Servicing

Bearings for Torsen differential, servicing - 6 Spd. Manual Transmission 01E

Special tools, testers and auxiliary items required:

^ Thrust plate VW 401
^ Thrust plate VW 402
^ Press tool VW 407
^ Press tool VW 412
^ Press tool VW 432
^ Thrust plate VW 447h
^ Clamping sleeve 3116
^ Thrust piece 3118
^ Separating device 22-115 mm, e.g. Kukko 17/2
^ Internal puller 30-37 mm, e.g. Kukko 21/5
^ Counter support e.g. Kukko 22/1





1 - Ball bearing for Torsen differential
2 - Torsen differential

^ Can only be serviced by manufacturer

3 - Inner race for needle bearing for Torsen differential
4 - Needle bearing for drive pinion/Torsen differential

Note:
The shims for the Torsen differential must be re-determined after replacing the following parts:

^ End cover
^ Inner race for needle bearing
^ Torsen differential
^ Ball bearing for Torsen differential





Press off ball bearing for Torsen differential

A - Separating device 22-115 mm, e.g. Kukko 17/2





Press on ball bearing for Torsen differential

^ Press piece 3118 with shoulder towards press tool VW 412





Pulling off inner race for needle bearing for Torsen differential

A - Inner race
B - Separating device 22-115 mm, e.g. Kukko 17/2





Pressing on inner race for needle bearing for Torsen differential





Pull out needle bearing for drive pinion/Torsen differential

A - Internal puller 30-37 mm, e.g. Kukko 21/5
B - Counter support, e.g. Kukko 22/1





Press in needle bearing for drive pinion/Torsen differential

- Press in needle bearing flush.