Tower "II", Assembling

Tower "II", assembling - 5 Spd. A/T 01V Front and All Wheel Drive





- Replace rectangular rings - 3 - and O-ring - 2 - on input shaft at clutch "E" - 1 -.
- Before inserting, thinly coat rectangular rings - 3 - and O-ring - 2 - with Vaseline. Use only Vaseline, other lubricating substances cause functional problems in the hydraulic transmission control.
- Make sure that rectangular rings - 3 - are fully seated all around in the input shaft groove.





- Press clutch "A" - 2 - onto clutch "E" - 1 - until stop.





- Install circlip - 2 - on input shaft - 1 -.





- Place axial needle bearing - 2 - onto clutch "A" - 1 -.
- Attach clutch "B" - 3 - onto disc carrier of clutch "A", using short lifting/turning motions.

^ All clutch discs "B" must engage in sequence in plate carrier of clutch "A".

- Check whether all plates are engaged, to do so lift clutch "B" a few millimeters and let fall.

^ If this produces a metallic sound, all plates are engaged.
^ If only a muted sound is heard, not all plates are engaged.





- Place adjustment shim - 2 - onto clutch "B" - 1 -.