Transmission Input Speed (RPM) Sensor G182 (Transmission With Hydraulic Control "E17"), Removing and Installing

Transmission Input Speed (RPM) Sensor G182 (transmission with hydraulic control "E17"), removing and installing - 5 Spd. A/T 01V Front and All Wheel Drive

Note:
^ On a transmission with hydraulic control "E17", Transmission Input Speed (RPM) Sensor G182 is an inductive sensor (secured on underside of valve body).
^ The allocation of the hydraulic control can be found in Technical Data.

Removing

- Remove valve body.
- Rotate valve body.





- Disconnect electrical harness connector at Transmission Input Speed (RPM) Sensor G182 - 1 -.

Note:
^ Ignore - arrows - and item - 2 -.





- Remove bolts and remove Transmission Input Speed (RPM) Sensor G182 - 1 -.

Note:
^ Disregard - 2 -.

Installing

Installation is in reverse order or removal, note the following:

- Position Transmission Input Speed (RPM) Sensor G182 - 1 - with spacer sleeves - 2 - on valve body and tighten bolts.

^ Spacer sleeve height: 20 mm.
^ Installation position: Transmission Input Speed (RPM) Sensor G182 contacts face toward center of valve body.

- Install valve body.
- Fill ATF.

Torque specification