C/D-Pillar Trim

Upper C/D-pillar Trim, Removing And Installing







1 - C/D-pillar trim

Removing
- Open out coat hook and remove screw - 3 -.
- Pivot down flap - 11 - on roof grab handle - 9 - at groove - 12 -.
Roof grab handle can be secured in the 'down' position by opening flap - 11 - fully.
- Remove screws - 2 - (2x)
- Unclip C/D-pillar trim - 1 -, starting at top.







Installing
- Insert trim - 1 - in rear-shelf mounts.
- Insert pin - 10 - on trim - 1 - in mount - 6 -.
- Insert clips - 8 - (7x) on trim - 1 - in mounts - 5 -.
- Clip trim - 1 - into place.







2 - Screws (2x)
3 - Screw (1x)
4 - Coat hook
5 - Mounts
6 - Mount
7 - Seal
- After installing make sure seal is correctly seated
8 - Clip(7x)
9 - Roof grab handle
10 - Pin
11 - Flap for roof grab handle
12 - Groove