Sender For Fuel Gauge -G, Removing and Installing

Sender For Fuel Gauge -G, Removing and Installing

Removing
- Fuel pump flange, removing.
- Carefully lift out fuel pump flange with fuel supply line connected and set aside.
- On the inside of the fuel pump flange disconnect connector for fuel gauge sender.







- Remove sender by pressing tab -arrows-.


NOTE:
- The fuel accumulator housing is shown in the illustration without the fuel tank.
- The illustration shows the fuel gauge sender for vehicles with front wheel drive.


Installing
Installation is in reverse order of removal, but do the following:


- Install sender for fuel gauge in guides of outer fuel accumulator housing and press down until locked in place.

Fuel pump flange, installing. Observe note regarding disconnecting battery.