With All Wheel Drive

Fuel Supply Unit And Sender For Fuel Gauge -G, Component Overview







1 - Sender for fuel gauge -G
- Float is cube-shaped
- Check resistance values:
2 - Return line
- With fuel pump
- on inside of cover flange
- Disconnecting: press unlatch buttons on connector piece
3 - Sealing ring
- Replace
- Installing: insert dry into fuel tank opening
4 - O-rings
- Always replace.
- Check installation position
5 - Return line
- From fuel distributor
- Mark before removal
- Note direction of arrow on flange
6 - Supply line
- To fuel distributor
- Mark before removing
- Note direction of arrow on flange
7 - Cover flange
- Location: Note arrow marking
8 - Harness connector
- For fuel Pump and sender for fuel gauge -G
9 - Union nut
- 60 Nm
10 - Wiring
- To fuel pump
- Attach with fuel resistant cable ties (item 11)
11 - Supply line
- Fuel pump/surge housing
12 - Nut M4
- 1.5 Nm
- Install toothed washer beneath.
13 - Nut M5
- 2 Nm
- Install toothed washer beneath.
14 - Fuel supply unit
- Fuel pump electrical checks
- Residual pressure, checking
15 - Fuel strainer
- Connected to fuel supply unit
- Can not be replaced individually
- Clean if dirty
16 - Surge housing lower section
- Installed in fuel tank
- Can not be removed